Honda Pilot: Combination Light Switch Removal, Installation, and Test

Removal/Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

1. Column Covers - Remove

2. Combination Light Switch - Remove

1. Disconnect the connector (A).
2. Remove the combination light switch (B) by pressing the tabs.

3. All Removed Parts - Install

1. Install the parts in the reverse order of removal.

Test

1. Combination Light Switch - Test

1. Inspect the connector terminals to be sure they are all making good contact.

• If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
• If the terminals are OK, go to step 2.

2. Check for continuity between the terminals in each switch position according to the tables.

Light Switch

Turn Signal Switch

Fog Light Switch

3. If the continuity is not as specified, replace the combination light switch.

CMBS OFF Switch Removal, Installation, and TestConnecting Rod Bearing Replacement