Honda Pilot: EVAP Canister Purge Valve Removal and Installation

Removal/Installation

1. Engine Cover - Remove

2. EVAP Canister Purge Valve - Remove

1. Disconnect the hose (A) and the connector (B).
2. Remove the EVAP canister purge valve (C).

3. All Removed Parts - Install

1. Install the parts in the reverse order of removal with a new O-ring.

EVAP Canister Removal and Installation

Removal/Installation

1. Vehicle - Lift

2. Rear wheels - Remove (AWD model)

3. Exhaust Pipe and Muffler - Remove (AWD model)

4. Propeller Shaft - Remove (AWD model)

5. EVAP Canister Assembly - Remove

1. AWD model: Place a transmission jack (A) under the rear differential (B).
2. AWD model: Remove the rear differential rear mount bolt (C) and the rear differential front mounting bracket bolts (D).
3. AWD model: Lower the transmission jack and rear differential about 1.18 in (30 mm).

   NOTE: Be careful not to damage the connecting parts.

4. Disconnect the quick-connect fitting (A) and the hoses (B).
5. Disconnect the connectors (C).

6. Remove the EVAP canister assembly (A) from the front side.

6. EVAP Canister - Disassembly

1. Remove the EVAP canister vent shut valve (A).
2. Remove the FTP sensor (B).

7. All Removed Parts - Install

1. Install the parts in the reverse order of removal with new O- rings.

EVAP Canister Vent Shut Valve Removal and Installation

Removal/Installation

1. EVAP Canister - Remove

2. EVAP Canister Vent Shut Valve - Remove

3. All Removed Parts - Install

1. Install the parts in the reverse order of removal with new O- rings.

EPS Motor/Control Unit Removal and InstallationEvaporator Core Removal and Installation