Honda Pilot: Evaporator Temperature Sensor Removal, Installation, and Test

Removal/Installation

*1: Test item

1. Connector (Driver's Footwell Light)- Disconnect

2. Driver's Heater Duct B - Remove

3. Front Evaporator Temperature Sensor - Remove

4. All Removed Parts - Install

1. Install the parts in the reverse order of removal.

Test

Front Evaporator Temperature Sensor

1. Front Evaporator Temperature Sensor - Test

1. Dip the sensor in ice water, and measure the resistance between terminals No. 1 and No. 2.
2. Then pour warm water on the sensor, and check for a change in resistance.
3. Compare the resistance readings with the specifications shown in the graph; the resistance should be within the specifications.
4. If the resistance is not as specified, replace the front evaporator temperature sensor.

Evaporator Expansion Valve Removal and InstallationExhaust Pipe and Muffler Removal and Installation