Honda Pilot: Sunvisor Removal and Installation

Removal

1. Sunvisor - Remove

1. Push the hook (A) with a flat-tip screwdriver through the hole in the front side of the bracket cover (B).

   NOTE: Make sure the hook is unlocked.

2. While pushing in the hook (A) with a flat-tip screwdriver, release the sunvisor (B) from the holder (C), and rotate the sunvisor backward 45 º.

   NOTE: Make sure the hook slides into the bracket cover as you rotate the sunvisor.

3. Disconnect the connector (A), and then remove the sunvisor (B).

NOTE: If the sunvisor cannot be removed, the hook has not rotated into the bracket cover. Repeat step 2 to rotate the hook.

2. Sunvisor Holder - Remove

1. If necessary, turn the sunvisor holder (A) 45 º counterclockwise, and then remove it from the holder grommet (B).

2. If necessary, remove the holder grommet (A).

Installation

1. Sunvisor - Check

1. If the side curtain airbag has deployed, replace the sunvisor, along with the other parts listed for side curtain airbag deployment.
2. If the side curtain airbag has not deployed, inspect the sunvisor for damage. A damaged sunvisor may cause the side curtain airbags to deploy improperly, possibly causing injury. Replace the sunvisor if it has any of the following damage:

• Any cracks in the sunvisor bracket (A)
• Any cracks in the sunvisor bracket cover (B)
• Any bends or cracks in the sunvisor shaft (C)
• Any cracks in the sunvisor base (D)
• Any cracks in the vanity mirror base (E)

3. If the holder grommet is damaged or stress-whitened, replace the holder grommet and the holder as an assembly.

1. Install the holder (A) into the holder grommet (B) by turning it 45 º clockwise.
2. Install the holder and holder grommet as an assembly into the body by pushing it until the hooks snap into place securely.

3. Sunvisor - Install

1. Connect the connector (A), and install the sunvisor (B).

Sunlight Sensor Removal and InstallationTailgate Dynamic Damper Removal and Installation