Honda Pilot: Brake Hose Removal and Installation

Removal

NOTICE

Do not spill brake fluid on the vehicle; it may damage the paint. If brake fluid gets on the paint, wash it off immediately with water.

NOTE: After removal, plug the ends of the hoses and the joints to prevent spilling brake fluid.

Front

1. Vehicle - Lift

2. Front Wheel - Remove

3. Front Brake Hose - Remove

1. Disconnect the brake line (A) from the brake hose (B).
2. Remove the brake hose clip (C).
3. Remove the banjo bolt (D), and disconnect the brake hose from the caliper body.

Rear

1. Vehicle - Lift

2. Rear Wheel - Remove

3. Rear Brake Hose - Remove

1. Disconnect the brake line (A) from the brake hose (B).
2. Remove the brake hose clip (C).
3. Remove the banjo bolt (D), and disconnect the brake hose from the caliper body.

Installation

NOTICE

Do not spill brake fluid on the vehicle; it may damage the paint. If brake fluid gets on the paint, wash it off immediately with water.

Front

1. Front Brake Hose - Install

NOTE:

• Check that all parts are free of dirt and other foreign particles.
• Replace parts with new ones whenever specified to do so.

1. Install the brake hose (A) with the brake hose mounting bolt (B).
2. Connect the brake hose to the caliper body with the banjo bolt (C) and new sealing washers (D).
3. Install the new brake hose clip (E) to the brake hose.
4. Connect the brake line (F) to the brake hose.

2. Brake System - Bleed

3. Brake Hose and Line - Check

NOTE:

• Check for leaks at hose and line joints or connections, and retighten if necessary.
• Check the brake hoses for interference and twisting.

4. Front Wheels - Install

Rear

1. Rear Brake Hose - Install

NOTE:

• Check that all parts are free of dirt and other foreign particles.
• Replace parts with new ones whenever specified to do so.

1. Install the brake hose (A) with the brake hose mounting bolt (B).
2. Connect the brake hose to the caliper body with the banjo bolt (C) and new sealing washers (D).
3. Install the new brake hose clip (E) to the brake hose.
4. Connect the brake line (F) to the brake hose.

2. Brake System - Bleed

3. Brake Hose and Line - Check

NOTE:

• Check for leaks at hose and line joints or connections, and retighten if necessary.
• Check the brake hoses for interference and twisting.

4. Rear Wheel - Install

Brake Booster Pressure Sensor Removal and InstallationBrake Master Cylinder Removal and Installation