Honda Pilot: Driver's Seat Position Sensor Removal and Installation

Removal/Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

NOTE: Do not turn the vehicle to the ON mode, while removing or installing the driver's seat position sensor.

1. Front Seat - Remove

NOTE: Raise the driver's seat all the way up.

2. Driver's Seat Position Sensor - Remove

1. Disconnect the connector (A).
2. Remove the bolt (B), then remove the driver's seat position sensor (C).

3. All Removed Parts - Install

1. Install the all removed parts in the reverse order of removal.

NOTE:

• During installation, install the new bolt to the specified torque.
• Be sure to install the harness so it is not pinched or interferes with other parts.
• After replacing the driver's seat position sensor with a new one, check the driver's seat position sensor operation.

4. SRS Operation - Confirm

1. Turn the vehicle to the ON mode, and check that the SRS indicator comes on for about 6 seconds and then goes off.

Driveshaft Support Base Removal and Installation

Removal and Installation

1. Right Driveshaft - Remove

2. Driveshaft Support Base - Removal

1. Remove the driveshaft support base (A), the two dowel bolts (B), and the flange bolt (C).
2. Remove the heat shield (D).

3. All Removed Parts - Install

1. Install the parts in the reverse order of removal.

Driver's Power Seat Adjustment Switch Removal and InstallationDriving Position Memory Switch Removal and Installation