Honda Pilot: Engine Oil Filter Removal and Installation

Removal

1. Vehicle - Lift

2. Engine Oil Filter - Remove

1. Remove the oil filter with the oil filter wrench.

2. Inspect the filter to make sure the rubber seal is not stuck to the oil filter seating surface of the engine.
3. Inspect the threads (A) and the rubber seal (B) on a new filter.
4. Clean the seat on the oil filter base.
5. Apply a light coat of new engine oil to the oil filter rubber seal.

   NOTE: Use only filters with a built-in bypass system.

Installation

1. Engine Oil Filter - Install

1. Install the oil filter by hand.
2. After the rubber seal seats, tighten the oil filter clockwise with the oil filter wrench.

Tighten: 3/4 Turn Clockwise

Tightening Torque: 12 N-m (1.2 kgf-m, 9 lbf-ft)

3. If four numbers or marks (1 to 4 or ▼ to ▼▼▼▼) are printed around the outside of the filter, you can use the following procedure to tighten the filter:

• Spin the filter on until its seal lightly seats against the oil filter base, and note which number or mark is at the bottom.
• Tighten the filter by turning it clockwise three numbers or marks from the one you noted. For example, if mark ▼ is at the bottom when the seal is lightly seated, tighten the filter until the mark ▼▼▼▼ comes around to the bottom.

2. After Install - Check

1. After installing, fill the engine with engine oil to the specified level, run the engine for more than 3 minutes, then check for oil leakage.

3. Maintenance Minder - Reset (With Maintenance Minder System)

1. If the Maintenance Minder required to replace the oil filter, reset the Maintenance Minder with the gauge (see "Resetting the Maintenance Minder").

Special Tool Required

• Oil Filter Wrench 07AAA-PLCA100

Engine Oil Filter Feed Pipe Removal and InstallationEngine Oil Jet Replacement