Honda Pilot: Front Passenger's Weight Sensor Removal and Installation

Removal

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

NOTE:

• Removal of the front passenger's weight sensors must be done according to Precautions and Procedures.
• The front passenger's weight sensor is part of the seat rail and must be replaced as an assembly.

1. 12 Volt Battery Terminal - Disconnect

NOTE: Wait at least 3 minutes before starting work.

2. Front Seat Frame (Passenger's side) - Remove

3. Front Passenger's Seat Rail/Front Passenger's Weight Sensors - Remove

Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

NOTE:

• Be sure to install the harness wires so they are not pinched or interfering with other parts.
• The front passenger's weight sensor is part of the seat rail and must be replaced as an assembly.

1. Front Passenger's Seat Rail/Front Passenger's Weight Sensors - Install

2. Front Seat Frame (Passenger's side) - Install

3. 12 Volt Battery Terminal - Connect

4. Seat Operation - Confirm

1. Move the front seat and the seat-back through their full ranges of movement, making sure the harness are not pinched or interfering with other parts.

5. Front Passenger's Weight Sensor Unit - Initialize

6. Front Passenger's Weight Sensor Unit - Operation Check

7. SRS Operation - Confirm

1. Turn the vehicle to the ON mode, and check that the SRS indicator comes on for about 6 seconds and then goes off.

Front Passenger's Weight Sensor Output Check After a Vehicle CollisionFront Passenger's Weight Sensor Unit Operation Check