Honda Pilot: Front Passenger's Weight Sensor Unit Operation Check

Procedure

1. After Replacing Front Passenger's Seat Component(s) - Check

After Replacing Front Passenger's Seat Component(s)

NOTE: Check the front passenger's weight sensor unit operation after any of these actions:

• Front passenger's seat component(s) replacement or removal (except front passenger's weight sensor unit).
• Front passenger's weight sensor(s) replacement or removal.
• After a vehicle collision.

2. HDS - Connect

3. Front Passenger's Weight Sensor Unit - Operation Check

Front Passenger's Weight Sensor Unit Operation Check

• Make sure all the components of the front passenger's seat are correctly installed.
• Position the front passenger's seat all the way rearward, and adjust the seat-back to the forward most position. Do not move the seat from this position until the output check is completed.
• Make sure nothing is on the front passenger's seat, including aftermarket seat covers or mats.
• Make sure nothing is in the front passenger's seat-back pocket.
• Keep the windows and the moonroof closed (if equipped).
• Do all initialization procedures, except test-driving, in the service bay.
• Make sure the vehicle is on level ground.
• Dehumidify inside of the vehicle with A/C.
• Do not touch the front passenger's seat during the operation check.
• Do not expose the front passenger's seat to sudden temperature changes.
• Make sure all aftermarket devices (amplifiers, fluorescent light, air purifiers, CB or HAM radios, etc.) are turned off.

1. Drive the vehicle, accelerate to 22 mph (36 km/h), then stop on level ground.

Front Passenger's Weight Sensor Removal and InstallationFront Passenger's Weight Sensor Unit Removal and Installation