Honda Pilot: Idle Stop Off Switch Removal, Installation, and Test

Removal/Installation

1. Center Console Panel - Remove

2. Idle Stop Off Switch - Remove

3. All Removed Parts - Install

1. Install the parts in the reverse order of removal.

Test

1. Center Console Panel - Remove

2. Idle Stop Off Switch - Test

1. Check the idle stop off switch according to the table.

NOTE:

• When an LED is located between terminals, check if the LED illuminates by connecting power and ground to the LED.
• Note this important operating characteristic; diode bias causes a diode to fully conduct electricity in one direction (forward), while not at all in the opposite direction (reverse).

2. If the switch does not work as described in the table, replace the switch.

HVAC Control Unit Removal and InstallationIgnition Coil and Spark Plug Removal and Installation