Honda Pilot: Output Shaft (Countershaft) Speed Sensor Removal and Installation

Removal/Installation

1. Front Bulkhead Cover - Remove

2. Air Intake Tube - Remove

3. Air Cleaner - Remove

4. 12 Volt Battery - Remove

5. 12 Volt Battery Box - Remove

1. Disconnect the connector (A).

6. 12 Volt Battery Duct - Remove

7. Battery Base - Remove

1. Remove the harness clamps (A).

8. Output Shaft (Countershaft) Speed Sensor - Remove

1. Disconnect the connector (A).
2. Remove the output shaft (countershaft) speed sensor (B) with the O-ring (C).

9. All Removed Parts - Install

1. Install the parts in the reverse order of removal.

NOTE:

• Check the connector for corrosion, dirt, or oil, and clean or repair if necessary
• Be sure to use a new O-ring when installing output shaft (countershaft) speed sensor.
• If necessary, add ATF to the proper level.

Multipurpose Camera Unit Removal and InstallationOutside Air Temperature Sensor Removal, Installation, and Test