Honda Pilot: Select/Reset/Information Switch Removal and Installation

Removal/Installation

NOTE: SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

1. Steering Wheel Trim- Remove

1. Adjust the steering column to the full telescopic out position.
2. Loosen the screws (A).

NOTE:

• Turn the steering wheel to the proper position to loosen the screws.
• The screws remains in the rear cover.

3. Remove the driver's airbag.

4. Pull out the steering wheel trim (A), then disconnect the connectors (B).
5. Remove the steering wheel trim.

2. Select/Reset/Information Switch - Remove

1. Remove the set plate (A) and the select/reset/information switch (B).

3. All Removed Parts - Install

1. Install the parts in the reverse order of removal.

Secondary Valve Body Removal and InstallationShift Cable Removal and Installation