Honda Pilot: Side Impact Sensor (First) Removal and Installation

Removal/Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

1. 12 Volt Battery Terminal - Disconnect

NOTE: Wait at least 3 minutes before starting work.

2. B-Pillar Lower Trim - Remove

3. Side Impact Sensor (First) - Remove

1. Disconnect the connector (A).
2. Remove the bolt (B), then remove the side impact sensor (first) (C).

4. All Removed Parts - Install

1. Install the parts in the reverse order of removal.

   NOTE:

   • During installation, install the new bolt to the specified torque.
   • Before installing the B-pillar lower trim, make sure the SRS indicator works normally.

5. SRS Operation - Confirm

1. Do the 12 volt battery terminal reconnection procedure, turn the vehicle to the ON mode, and check that the SRS indicator comes on for about 6 seconds and then goes off.

Side Engine Mount Removal and InstallationSide Impact Sensor (Second) Removal and Installation