Honda Pilot: Torque Converter Housing Countershaft Bearing Replacement

Replacement

1. Countershaft Bearing - Remove

1. Remove the countershaft bearing (A) using the 25－40 mm adjustable bearing puller and a commercially available 3/8"-16 slide hammer (B).

2. Remove the ATF guide plate (A), and replace it if it is damaged.

2. Countershaft Bearing - Install

1. Install the ATF guide plate (A).

2. Install the countershaft bearing (A) in the direction shown.

3. Drive the countershaft bearing (A) using the 15 x 135L driver handle and the 72 x 75 mm bearing driver attachment; install the bearing outer notch-cut (B) to a depth (C) of 0－0.14 mm (0－0.0055 in) below the torque converter housing surface (D).

Special Tool Required

Adjustable Bearing Puller, 25－40 mm 07736-A01000B*

• Bearing Driver Attachment, 72 x 75 mm 07746-0010600

• Driver Handle, 15 x 135L 07749-0010000

*: 07736-A01000B must be used with commercially available 3/8"-16 slide hammer.

Tire Pressure Sensor Removal and InstallationTorque Converter Housing Differential Carrier Bearing Outer Race Replacement