Honda Pilot: Torque Converter Housing Differential Carrier Bearing Outer Race Replacement

Replacement

NOTE:

• Replace the carrier bearing with a new one whenever the bearing outer race is replaced.
• Adjust the preload after replacing the bearing and the outer race.
• Apply a light coat of clean ATF on all parts before installation.
• Unless otherwise indicated, illustrations used in the procedure are for AWD.

1. Differential Carrier Bearing Outer Race - Remove

1. Remove the carrier bearing outer race (A) and the spacer (B).

2. Differential Carrier Bearing Outer Race - Install

1. Install the spacer (A) by aligning the tab (B) with the groove (C).
2. Install the carrier bearing outer race (D).

3. Drive the bearing outer race securely using the 15 x 135L driver handle and the 83 mm attachment.

Special Tool Required

• Driver Handle, 15 x 135L 07749-0010000

• Attachment, 83 mm 07HAD-SG00100

Torque Converter Housing Countershaft Bearing ReplacementTorque Converter Housing Differential Oil Seal Replacement