Honda Pilot: Transmission Fluid Pressure Switch E (6th Clutch) Removal and Installation

Removal/Installation

1. Front Bulkhead Cover - Remove

2. Air Intake Tube - Remove

3. 12 Volt Battery - Remove

4. 12 Volt Battery Box - Remove

1. Disconnect the connector (A).

5. Transmission Fluid Pressure Switch E (6th Clutch) - Remove

1. Disconnect the connector (A).
2. Remove transmission fluid pressure switch E (6th clutch) with the sealing washer (B).

6. All Removed Parts - Install

1. Install the parts in the reverse order of removal.

NOTE:

• Check the connector for corrosion, dirt, or oil, and clean or repair if necessary.
• Be sure to use a new sealing washer when installing transmission fluid pressure switch E (6th clutch) .
• Tighten the switch by gripping the metal part, not the plastic part.
• If necessary, add ATF to the proper level.

Transmission Fluid Pressure Switch D (5th Clutch) Removal and InstallationTransmission Housing Differential Carrier Bearing Outer Race Replacement