Honda Pilot: Transmission Housing Differential Carrier Bearing Outer Race Replacement

Replacement

NOTE:

• Replace the carrier bearing with a new one whenever the bearing outer race is replaced.
• Adjust the preload after replacing the bearing and the outer race.
• Apply a light coat of clean ATF on all parts before installation.
• Unless otherwise indicated, illustrations used in the procedure are for AWD.

1. Differential Carrier Bearing Outer Race - Remove

1. Remove the carrier bearing outer race (A), the spacer (B), and the 85 mm thrust shim (C) by heating the transmission housing to about 212 ºF (100 ºC) using a heat gun (D).

NOTE: Do not heat the transmission housing more than 212 ºF (100 ºC).

2. Differential Carrier Bearing Outer Race - Install

1. Install the 85 mm thrust shim (A).
2. Install the spacer (B) by aligning the tab (C) with the groove (D).
3. Install the carrier bearing outer race (E).

Special Tool Required

• Driver Handle, 15 x 135L 07749-0010000

• Attachment, 83 mm 07HAD-SG00100

Transmission Fluid Pressure Switch E (6th Clutch) Removal and InstallationTransmission Housing Differential Oil Seal Replacement