Honda Pilot: Transmission Housing Mainshaft Bearing Replacement

Replacement

1. Reverse Idler Gear - Remove

2. Mainshaft Bearing - Remove

1. To remove the mainshaft bearing (A), expand the snap ring using the snap ring pliers.
2. Push the mainshaft bearing out using the 15 x 135L driver handle and the 80 mm I.D. seal driver attachment.

   NOTE: Do not remove the snap ring unless it is necessary to clean the groove in the transmission housing.

3. Mainshaft Bearing - Install

1. Install the mainshaft bearing (A) in the direction shown.
2. Expand the snap ring using the snap ring pliers.
3. Insert the mainshaft bearing part-way using the 15 x 135L driver handle and the 80 mm I.D. seal driver attachment.
4. Release the snap ring pliers.
5. Push the mainshaft bearing down until the snap ring snaps in place around it.

6. After installing the bearing, check that the snap ring (A) is seated in the bearing and the housing groove, and that the snap ring end gap (B) is 0－7 mm (0－0.28 in).

4. Reverse Idler Gear - Install

Special Tool Required

• Snap Ring Pliers 07LGC-0010100

• Driver Handle, 15 x 135L 07749-0010000

• Seal Driver Attachment, 80 mm I.D. 07VAD-P8A010A

Transmission Housing Idler Gear Shaft Bearing ReplacementTransmission Housing Reverse Idler Gear Removal and Installation