Honda Pilot: APP Sensor Signal Inspection

Inspection

NOTE:

• This procedure checks the APP sensor in its fully closed position. In any other position, the APP sensor stores DTCs which are covered in other troubleshooting procedures.
• Check for Pending or Confirmed DTCs with the HDS before doing this procedure. If any DTCs are indicated, troubleshoot them first, then do this procedure.
• Press the accelerator pedal several times to check its operation. If it does not operate smoothly, check the pedal. If you find a problem, replace the accelerator pedal module.

1. HDS - Connect

2. APP Sensor Signal - Inspect

1. Make sure the accelerator pedal is not pressed, then check the APP SENSOR in the DATA LIST with the HDS.

• If it is 0 %, the APP sensor is OK.
• If it is not 0 %, update the PCM if it does not have the latest software, or substitute a known-good PCM, then go to step 2.

2. Make sure the accelerator pedal is not pressed, then check the APP SENSOR in the DATA LIST with the HDS.

• If it is 0 %, the APP sensor is OK.
• If it is not 0 %, replace the accelerator pedal module, then go to step 1.

Air Cleaner Element Removal, Installation, and InspectionATF Pump Inspection