Honda Pilot: Front Door Sash Outer Trim Removal and Installation

Removal/Installation

1. Front Door Sash Outer Trim - Remove

1. Lower the front door glass.
2. Pull away the front door weatherstrip (A) and remove the clip.
3. Remove the screw from the front door outer molding (B).

4. Pull out the glass run channel (A) as needed.
5. Pull out the upper edge of the front door sash outer trim (B) from the edge of the sash, and cut the double-sided adhesive tapes (C) with a utility knife.

6. Release the hook (A) of the front door sash outer trim (B) from the front door outer molding (C).

   NOTE: Pull the front door outer molding only as needed to release the hook (A). Excessive pulling will cause the molding to get damaged resulting in replacement.

7. Release the hook (D) of the front door sash outer trim from the sash (E), and then remove the front door sash outer trim.
8. Remove any remaining double-sided adhesive tapes from the front door sash outer trim and the front door sash, then clean the surfaces with a sponge dampened with isopropyl alcohol. After cleaning, keep oil, grease, and water from getting on the clean surface.

2. All Removed Parts - Install

1. Install the parts in the reverse order of removal.

   NOTE : If you are reusing the original front door outer trim (A), apply adhesive primer to the areas where the new double-sided adhesive tapes (B) will be applied, and then attach the new double-sided adhesive tapes to the front door outer trim on the scribes (C) as shown.

Adhesive tape

(B): Thickness 0.8 mm (0.031 in)

Width 10 mm (0.39 in)

Length 450 mm (17.72 in)

Front Door Regulator Removal and InstallationFront Door Weatherstrip Removal and Installation