Honda Pilot: Side Airbag Removal and Installation

Removal/Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

NOTE:

• If replacing the side airbag after deployment, refer to Component Replacement/Inspection After Deployment for a complete list of other parts that must also be replaced.
• When troubleshooting, do not remove the front seat. Disconnect only the side airbag inflator connector from under the front seat.

1. 12 Volt Battery Terminal - Disconnect

NOTE: Wait at least 3 minutes before starting work.

2. Front Seat - Remove

3. Front Seat-Back Cover - Remove

4. Side Airbag - Remove

1. Remove the nuts (A), then remove the side airbag (B).

5. All Removed Parts - Install

1. Install the parts in the reverse order of removal.

NOTE:

• During installation, install the new mounting nut to the specified torque.
• If the side airbag lid is secured with tape, remove the tape.
• Do not open the lid on the side airbag cover.
• Make sure that the seat-back cover/pad is installed properly. Improper installation may prevent proper deployment.
• Be sure to install the harness so that they are not pinched or interfering with other parts.

6. Seat Operation - Confirm

1. Move the front seat and the seat-back through their full ranges of movement, making sure the harness are not pinched or interfering with other parts.

7. SRS Operation - Confirm

1. Do the 12 volt battery terminal reconnection procedure, turn the vehicle to the ON mode, and check that the SRS indicator comes on for about 6 seconds and then goes off.

Shift Solenoid Valve C Removal and InstallationSide Curtain Airbag Removal and Installation