Honda Pilot: Torque Converter Housing Mainshaft Bearing and Oil Seal Replacement

Replacement

NOTE: Unless otherwise indicated, illustrations used in the procedure are for AWD.

1. Oil Seal - Remove

2. Mainshaft Bearing - Remove

1. Remove the mainshaft bearing (A) using the 25－40 mm adjustable bearing puller and a commercially available 3/8"-16 slide hammer (B).

3. Mainshaft Bearing - Install

1. Install the mainshaft bearing until it bottoms using the 15 x 135L driver handle and the 62 x 68 mm bearing driver attachment.

4. Oil Seal - Install

1. Install the oil seal flush with the torque converter housing using the 15 x 135L driver handle and the 72 x 75 mm bearing driver attachment.

   NOTE: Do not drive the oil seal into the torque converter housing until it bottoms out, it will block the fluid return passage and cause transmission damage.

Special Tool Required

• Adjustable Bearing Puller, 25－40 mm 07736-A01000B*

• Bearing Driver Attachment, 62 x 68 mm 07746-0010500

• Bearing Driver Attachment, 72 x 75 mm 07746-0010600

• Driver Handle, 15 x 135L 07749-0010000

*: 07736-A01000B must be used with commercially available 3/8"-16 slide hammer.

Torque Converter Housing Idler Gear Shaft Bearing ReplacementTorque Converter Housing Secondary Shaft Bearing Replacement