Honda Pilot: Transfer Output Shaft Installation Height Inspection and Adjustment

Adjustment

NOTE: If the transfer output shaft, the transfer output shaft bearing, the transmission housing bearing, the transmission housing, or the torque converter housing were replaced, adjust the transfer output shaft installation height with the 28.5 mm thrust shim.

1. Transfer Output Shaft - Install

1. Install the transfer output shaft (A).
2. Install the 28.5 mm thrust shim (B).

   NOTE: If you install a new 28.5 mm thrust shim, use the same thickness shim as the old one.

2. Transfer Output Shaft Installation Height - Inspect/ Adjust

1. Install a new gasket (A).
2. Measure the height (B) of the transfer output shaft installation between the surface of the gasket (C) and the top of the 28.5 mm thrust shim (D) in at least three places.

   Use the average as the actual height.

Transfer Output Shaft Installation Height

  Standard: 47.26－47.30 mm (1.8606－1.8622 in)

3. If the measurement is out of the standard, remove the 28.5 mm thrust shim and measure its thickness.
4. Select and install a new thrust shim, then recheck the installation height.

Thrust Shim, 28.5 mm

1. 1.82 mm (0.0717 in)
2. 1.84 mm (0.0724 in)
3. 1.86 mm (0.0732 in)
4. 1.88 mm (0.0740 in)
5. 1.90 mm (0.0748 in)
6. 1.92 mm (0.0756 in)
7. 1.94 mm (0.0764 in)
8. 1.96 mm (0.0772 in)
9. 1.98 mm (0.0780 in)
10. 2.00 mm (0.0787 in)
11. 2.02 mm (0.0795 in)
12. 2.04 mm (0.0803 in)
13. 2.06 mm (0.0811 in)
14. 2.08 mm (0.0819 in)
15. 2.10 mm (0.0827 in)
16. 2.12 mm (0.0835 in)
17. 2.14 mm (0.0843 in)
18. 2.16 mm (0.0850 in)
19. 2.18 mm (0.0858 in)
20. 2.20 mm (0.0866 in)
21. 2.22 mm (0.0874 in)
22. 2.24 mm (0.0882 in)
23. 2.26 mm (0.0890 in)
24. 2.28 mm (0.0898 in)
25. 2.30 mm (0.0906 in)
26. 2.32 mm (0.0913 in)
27. 2.34 mm (0.0921 in)
28. 1.78 mm (0.0701 in)
29. 1.80 mm (0.0709 in)

3. Transfer Output Shaft - Remove

1. Remove the 28.5 mm thrust shim (A).
2. Remove the transfer output shaft (B).

Transfer Assembly InspectionValve Inspection