Honda Pilot: Wheel Bearing End Play Inspection

Inspection

1. Vehicle - Lift

2. Front Wheels and Rear Wheels - Remove

3. Wheel Bearing End Play - Inspect

1. Install suitable flat washers (A).
2. Install the wheel nuts (B).
3. Tighten the nuts to the specified torque to hold the brake disc or the brake disc/drum securely against the hub.
4. Attach the dial gauge (C).
5. Place the dial gauge against the hub flange.
6. Measure the bearing end play while moving the brake disc or the brake disc/drum inward and outward.

Wheel bearing end play:

  Front/Rear: 0－0.05 mm (0－0.0020 in)

7. If the bearing end play measurement is more than the standard, replace the wheel bearing or the hub bearing unit.

• Front wheel bearing.
• Rear hub bearing unit.

4. Front Wheels and Rear Wheels - Install

Water Pump InspectionWheel Runout Inspection